User manual
5
InStallatIon
When deciding where to place the DVI KVM Switch, consider the cable
lengths required to make all conguration connections, particularly of USB
cables, which typically maintain optimal signal strength when limited to
about 4.5 m (15 ft.). NOTE: Avoid placing cables near devices that output
electrical “noise” (for example, A/C equipment and uorescent lights).
CONNECTING THE CONSOLE
1. Turn off all computers to be connected to the switch.
2. Connect your PS/2 keyboard and PS/2 mouse to
the rear-panel PS/2 keyboard and mouse ports
(as designated by the keyboard and
mouse icons on the switch).
3. Connect your DVI monitor cable to
the console DVI monitor port (as
designated by the console monitor
icon on the rear of the switch).
4. Connect any USB devices you wish
to share as “USB Device 1” or “USB
Device 2” to the USB input ports on
the front panel of the switch. NOTE:
When sharing USB devices, do not
switch while the devices are operating.
5. Connect the included power adapter to the power
jack on the rear panel of the switch, then plug the
adapter into an available AC power outlet.