IBC-607IR / IBC-637IR Network Bullet Camera Hardware Installation Guide
Package Contents Camera Quick Installation Guide Software CD Accessories Network Bullet Camera Brief product information and quick installation IP Surveillance Software Intelligent IP Installer User Manuals Language Packs (1) Three-axis wall/ ceiling mounting bracket (2) Screws and anchors for wall or ceiling mounting (3) Sun Shield (4) Screws for sun shield (5) Cat 5e Female Coupler
Hardware Description LED Indication Steady red during boot up process. Power Steady blue after boot sequence has completed. Flashing purple during firmware upgrade. Network MicroSD Card Flash yellow while Network activity. Steady yellow means MicroSD card ready. Flash yellow while accessing MicroSD card.
Factory Reset Reset: With the camera turned on, press the reset button briefly to reboot the camera, or hold the reset button for 10 seconds to set all settings back to factory default values. Hardware Installation 1. Use the two supplied screws to fix the base plate to a flat surface. 2. Loosen the screws on the bracket in order to adjust the camera’s viewing area. 3. Tighten the screws at the two joints of the bracket to fix the camera in place. 4.
. Connect the camera via PoE Using a standard RJ-45 network cable, connect the bullet camera to an IEEE802.3af/at compliant PoE switch or PoE injector. 6. Connect the camera without PoE 1. Connect the power adaptor to the dome camera 2. Using a standard RJ-45 network cable, connect the camera to a normal Ethernet Switch or Router 7. Software Installation Insert the Installation CD into a CD or DVD drive and follow the instructions given by the Quick Installation Guide.
INTELLINET NETWORK SOLUTIONS™ offers a complete line of active and passive networking products. Ask your local computer dealer for more information or visit www.intellinet-network.com Copyright © INTELLINET NETWORK SOLUTIONS All products mentioned are trademarks or registered trademarks of their respective owners.
