User Manual User Manual

20"
"
Hint
The following parameters are shown on the VLAN-Stacking Table Setting screem:
■ Tag Protocol ID – The Tag Protocol Identifier specifies the Ether type of incoming packets on a tunnel port.
(Range: 0 x 0600 – 0 x FFFF hexadecimal; Default: 0 x 88a8)
■ PVID - The stacking VLAN Port VLAN Identifier. The PVID determines the stacking VLAN tag for
single-tagged packets forwarded to an enabled S-VLAN port.
■ Provider Network Port – This lets you set the S-VLAN membership mode for the selected interface. This
mode is used to segregate and preserve customer VLAN IDs for traffic crossing the service provider network.
(Default: Disable)
■ Enable - Indicate a port linked to a service provider (an 802.1Q Tunnel port).
■ Disable - Indicate a port linked to a customer.