User Manual User guide

WMM Enable: Click the check box (then click “Apply”) to enable the WMM
function, which then lets you congure the WMM Power Save and
Direct Link Setup functions.
• WMM – Power Save Enable: Click the check box to enable, then
click “Setting” to further congure the function as “AC_BK,” “AC_BE,”
“AC_VI” or “AC_VO.”
• Direct Link Setup Enable: Click the check box to enable, then click
“Apply” to further congure the function (all within the Direct Link panel).
- MAC Address: Specify the MAC address of the client adapter you
want to direct link to and click “Apply” to add to the DLS Status
table (below).
- Timeout Value: Specify the timeout value for the direct link being
set up.
ABOUT
On this screen, you can click the hyperlink for information on the wireless
chipset manufacturer. Basic information about the utility (driver, EEPROM
version, etc.) also displays, as do various addresses for quick reference.
WPS CONFIGURATION
The adapter supports WPS (Wi-Fi Protected Setup), allowing connection
to wireless APs that also support WPS without complicated procedures.
CONFIGURATION
23