User Manual Owner manual

length and “Hex” as key format, you’ll see the

message at the right of “Key Format” is “Hex

(10 characters,” which means the length of the

WEP key is 10 characters.

Default Tx Key

You can set up to four sets of WEP keys, and

you can decide which key is being used by

default here. If you don’t know which one

you should use, select “Key 1.”

Encryption Key 1

to 4

Input WEP key characters here. The number

of characters must be the same as the number

displayed in the “Key Format” field. You can

use any alphanumerical characters (0-9, a-z

and A-Z) if you select “ASCII” key format; if

you select “Hex” as the key format, you can

use characters 0-9, a-f and A-F. You must

enter at least one encryption key here; if you

enter multiple WEP keys, they should all be

different.

Enable 802.1x

Authentication

Check to enable 802.1x user authentication.

Refer to Section 2-7-5 for detailed instructions.

After you finish with the settings, click “Apply” and the following

message will be displayed:

When you see this message, the settings you made are

successfully saved. Click “Continue” to go back to the previous

page and continue with other settings, or click “Apply” to restart the

wireless access point. Changes will take effect after about 30

seconds.