- Intellinet Wireless Network IP Camera User's Guide

WIRELESS NETWORK IP CAMERA User’s Guide

Wireless Configuration

This screen is used to configure wireless setting to match with your Access Pointer for the wireless

network connection.

Wireless Setup

1. Use the connection Mode to determine the type of wireless communication for the Wireless

Network IP Camera. There are two choices of infrastructure mode and Adhoc mode. The

default setting for the connection mode is Infrastructure.

2. Set the Service Area Name (SSID) as per AP setting to which user wants to connect. i.e.

intellinet5 in our case.

3. The channel rate is set to channel 1 as a default

4. The default setting for the “Tx rate” is Auto, it is more convenient to keep it as a default,

however, users can set it to 5.5.mbps or 11 mbps as per his/her requirement.

NOTE

Keep in mind the slide switch on the rear panel is positioned to LAN-WAN or WLAN setting for

the wireless communication to take effect.