User Manual

FIRMWARE 
Firmware updates, if available, are contained within the latest Intellijel Firmware Updater
application, which you can download from the product’s page on the Intellijel.com website. The
application is available in both Macintosh and Windows formats, and will install firmware into your
module over USB. Use the drop-down lists at the top of the application to select the product you
wish to update, and the firmware version you want to install. Click the Instructions button to read
specific instructions for updating your module.
Steppy displays the current version number during start up. Specifically, the top row of buttons
indicates the first digit in the FW version, and the second row of buttons indicates the second digit.
For example, if Steppy was running firmware version 2.4, then it would light the second button in
the top row and the fourth button in the bottom row, as show below:
1U / 3U Toggle 
Steppy’s 1U and 3U versions run the same firmware, which supports both button orientations. The
correct orientation is loaded at the factory, and any subsequent firmware updates will retain the
correct orientation. However, if you one day find your Steppy 1U operating as if all the button
functions are inverted, it means the 3U orientation is running, instead. To switch back to the 1U
orientation, simply hold the SELECT button at startup, and the orientation will toggle back to the 1U
layout.
Firmware Change Log 
1.20 (2020-01-10)
● NEW FEATURE : Latching Loopy mode . When holding down buttons to define the Loopy steps,
press the SELECT button to Latch your loop. Press a step button to unlatch it. If you change
your Loopy steps, you will need to press SELECT to latch them again.
Steppy 1U Manual 37