intellijel Steppy 1U 4-Track 64-Step Programmable Gate Sequencer : User Manual : Page 30

To delete a preset from memory:

1. Press the red EDIT button to enter Edit mode.

2. Short-press (< 1 sec) the LOAD button followed by the top-row button corresponding to

the preset you want to delete.

This loads that preset into active memory (as indicated by the rapidly flashing button).

3. Long-press (> 1 sec) the LOAD button. All buttons will flash, and the contents of the

previously selected preset will be deleted.

NOTE 1 : To erase ALL presets from memory, turn off Steppy, then long-press the LOAD

button while you power it back on.

NOTE 2 : If you power Steppy off and back on, it will reload that last saved or loaded preset —

it does not retain any unsaved pattern or track changes. So remember to always save your

work if you wish to return to it later.

[10] Value buttons

Use this top row of buttons to set values for the parameters you select with the bottom row of

buttons. In general, this row behaves like a horizontal value slider, with lower values to the left

and higher values to the right. The specific values assigned to each button depend on the

parameter being edited, and these exact values are detailed under each parameter button’s

description, above.

 

Steppy 1U Manual 29