intellijel Steppy 1U 4-Track 64-Step Programmable Gate Sequencer : User Manual : Page 21

Edit Mode 

In Edit Mode, the Multifunction buttons select and modify various parameters (such as gate length,

clock division, swing, etc.), as indicated by the labels beneath the bottom row of buttons. The red

LED next to the EDIT button turns on when Edit Mode is on.

Note: Steppy can be in both Select mode ( yellow LED) and Edit mode ( red LED) simultaneously. If

you’re currently in Edit Mode, you can enter Select mode to select which track you wish to edit.

[1] EDIT button

Short-press (< 1 sec) this button to put Steppy into Edit Mode. The red LED next to the EDIT

button turns on when Edit Mode is on.

Edit Mode uses the bottom row of multifunction buttons to select which parameter to edit (as

indicated by the labels below the bottom buttons, such as GATE, CLK ÷, SWING, etc). Edit

Mode uses the top row of buttons [10] to modify the selected parameter value (with, in

general, the ‘lowest’ possible value corresponding to the leftmost button, and the ‘highest’

possible value corresponding to the rightmost button).

Long-press ( > 1 sec) the EDIT button to enable a special Step Edit Mode , which allows

ratcheting, along with per-step editing of Gate Length, Step Delay and Probability.

Steppy 1U Manual 20