User Manual

You can use a tool like ModularGrid to assist in your planning. Failure to adequately power your
modules may result in damage to your modules or power supply. If you are unsure, please contact
us before proceeding.
Installing Your Module 
When installing or removing a module from your
case always turn off the power to the case and
disconnect the power cable. Failure to do so may
result in serious injury or equipment damage.
Ensure the 10-pin connector on the power cable is
connected correctly to the module before
proceeding. The red stripe on the cable must line
up with the -12V pins on the module’s power
connector. Different modules use different ways to
indicate the -12V pins. Some may be labelled with
“-12V;” a white stripe next to the -12V pins; the
words “red stripe;” or some combination of these.
Additionally, some modules may have shrouded
headers, thus preventing backward connections.
Most modules will come with the cable already connected but it is good to double check the
orientation. Be aware that some modules may have headers that serve other purposes so ensure
the power cable is connected to the right one.
The other end of the cable, with a 16-pin connector,
connects to the power bus board of your Eurorack
case. Ensure the red stripe on the cable lines up
with the -12V pins on the bus board. On Intellijel
power supplies the pins are labelled with “-12V” and
a thick white stripe.
If you are using another manufacturer’s power
supply, check their documentation for instructions.
Quadratt 1U Manual 4