User Manual

Inputs and Outputs 
[A] CV 1 - The CV input for controlling the
level of channel 1. A +5 V input with
the channel’s attenuator fully
clockwise, response knob fully linear,
and LEVEL control fully
counterclockwise results in
approximately unity (1:1) gain.
[B] CV 2 - The CV input for controlling the
level of channel 2. If nothing is
connected to this jack, the CV is taken
from CV 1.
[C] CV 3 - The CV input for controlling the
level of channel 3. If nothing is
connected to this jack, the CV is taken
from CV 2.
[D] CV 4 - The CV input for controlling the
level of channel 4. If nothing is
connected to this jack, the CV is taken
from CV 3.
[E] IN 1 - The input to channel 1.
[F] IN 2 - The input to channel 2.
[G] IN 3 - The input to channel 3.
[H] IN 4 - The input to channel 4.
[I] OUT 1 - The signal output for channel 1. If nothing is connected to this jack the output is mixed
into OUT 2.
[J] OUT 2 - The signal output for channel 2. If nothing is connected to this jack the output is mixed
into OUT 3.
[K] OUT 3 - The signal output for channel 3. If nothing is connected to this jack the output is mixed
into OUT 4.
[L] OUT 4/MIX - The signal output for channel 4. If the other three OUT jacks are left unconnected,
this jack can function as the output of a 4-channel mix.
Quad VCA Manual 7