User Manual

[10] ⅛” TRS MIDI Output (104HP Only)
MIDI output connector on a ⅛” TRS (Type-A) jack. When used with a MIDI 1U module, the jack
functions as a MIDI Thru — passing along any MIDI data received at the ⅛” TRS MIDI Input [9]
jack. If you need to connect a 5-pin MIDI device to this jack, you’ll need to purchase a standard
Type-A ⅛” TRS-to-5-pin MIDI adapter. Or connect it directly (no adapter required) to any other
device with a Type-A compatible TRS MIDI input (such as another Palette case, or any other device
that supports the MIDI 2.0 standard Type-A TRS connection).
[11] USB MIDI Input
MIDI input connector on USB. MIDI sent into the USB port is routed to the 10-pin MIDI Connector
socket on the Palette’s circuit board , where it can be connected to a MIDI input module, such as the
Intellijel MIDI 1U or the older µMIDI 1U.
[12] Mounting for 1U modules
Depending on which Palette Case you own, this area provides either 62HP or 104HP of mounting
space for Intellijel-format 1U modules.
[13] Mounting for 3U modules
Depending on which Palette Case you own, this area provides either 62HP or 104HP of mounting
space for eurorack standard 3U modules, up to a depth of 45.5mm. At each of the extreme edges
(occupying less than 1 hp) the depth is 37.42mm.
Palette Cases Manual 7