User Manual

[D] Link Connector
Use this 3-pin connector to attach either a Mixup module or a Pedal I/O module to the two ¼”
connectors on the top of the Palette.
● Mixup (OUT) : Connect the 3-wire link cable (provided with your Mixup module), between the
Link Connector on the Palette circuit board
and the CHAIN-OUT connector on your
Mixup.
In this scenario, unbalanced stereo audio
from Mixup’s output is sent out Palette’s two
corresponding Audio Jacks.
● Mixup (IN) : Connect the 3-wire link cable (provided with your Mixup module), between the Link
Connector on the Palette circuit board and the CHAIN-IN connector on your Mixup.
In this scenario, unbalanced stereo audio
arriving at the Palette’s corresponding pair
of Audio Jacks will be mixed with Mixup’s
own front panel inputs.
Palette Cases Manual 11