User Manual

[A] Power Connectors
These are the16-pin power connectors for powering your modules. The Palette 62 has 12
connectors, and the Palette 104 has 24. The connectors are shrouded to ensure that properly
manufactured ribbon cables can be connected only one way — with the red (-12V) wire to the right.
Make sure, if you’re using cables from another
manufacturer or sourced elsewhere, that the
red stripe is on the right when plugged in.
Plug the other end of the ribbon cables into
the Eurorack modules you wish to power —
being careful (if the module’s power connector
isn’t shrouded) to align the red stripe with the
-12V pins on the module. These pins are
indicated differently by different
manufacturers, but often will say “-12V,” or
“Red Stripe,” or have a visible white stripe
next to the -12V side of the connector. See your Eurorack modules for details concerning its -12V
power nomenclature.
[B] Audio Jacks Connector
These 6-pin connectors are for attaching either a balanced audio input or balanced audio output
module to the ¼” TRS connectors on the top of the Palette. The Palette 62 has one Audio Jacks
Connector (for its single pair of TRS jacks), while the Palette 104 has two Audio Jacks Connectors
(for its two pairs of TRS jacks). Some examples:
● Stereo Line Out 1U : Using the cable
provided with your Stereo Line
Out 1U module, connect it to the
Audio Jacks Connector (or to one of
the two Audio Jacks Connectors on
the 104HP case). Once connected,
the corresponding pair of Palette’s
TRS audio jacks function as L/R
audio outputs for the Palette case.
Palette Cases Manual 9