User Manual

orientation. Be aware that some modules may have
headers that serve other purposes so ensure the
cable is connected to the right one.
The other end of the cable, with a 16-pin connector,
connects to the power bus board of your Eurorack
case. Ensure the red stripe on the cable lines up with
the -12V pins on the bus board. On Intellijel power
supplies the pins are labelled with the label “-12V”
and a thick white stripe:
If you are using another manufacturer’s power
supply, check their documentation for instructions.
Once connected, the cabling between the module and power supply should resemble the picture
below:
Before reconnecting power and
turning on your modular system,
double check that the ribbon
cable is fully seated on both
ends and that all the pins are
correctly aligned. If the pins are
misaligned in any direction or
the ribbon is backwards you can
cause damage to your module,
power supply, or other modules.
After you have confirmed all the
connections, you can reconnect
the power cable and turn on
your modular system. You
should immediately check that all your modules have powered on and are functioning correctly. If
you notice any anomalies, turn your system off right away and check your cabling again for
mistakes.
 
Morgasmatron Manual 4