User Manual

Overdrive With Wet/Dry Control 
If you flip on the Overdrive circuit for Filter A, connect it in parallel with Filter B (with DRY active so it
unfiltered), and monitor the MIX out, then you can use the XFADE for adjusting the overall amount
of overdriven signal present in the mix.
1. Patch an audio signal into Morgasmatron’s IN A and nothing plugged into IN B .
2. Patch the Morgasmatron’s MIX output into your audio monitoring system.
3. Set the Morgasmatron to Parallel mode ( Series/Parallel Switch in the down position).
4. Rotate the XFADE knob fully counterclockwise so that you hear only the output of Filter A.
5. Switch on the Overdrive circuit for Filter A, and select the Mode , Cutoff , Q , Q-Drive and IN A to
achieve the sound you want at “maximum” aggression.
6. Rotate the XFADE knob fully clockwise and set the side B DRY switch to ON so that you hear
only the original unaffected dry signal.
7. Use the XFADE knob to alter the balance between the dry and distorted signal. You can use CV
to modulate this balance if so desired.
 
Morgasmatron Manual 16