User Manual

Overdrive With Tone Control 
If you flip on the Overdrive circuit for Filter A, connect it in series with Filter B, and monitor the OUT
B, then you can use Level B for controlling the distorted signal level and Filter B as a tone control
for “taming” the aggression — modulating the tone over time or adjusting the overall amount of
overdriven signal present in the mix.
1. Patch an audio signal into Morgasmatron’s IN A .
2. Patch the Morgasmatron’s OUT B into your audio monitoring system.
3. Set the Morgasmatron to Series mode ( Series/Parallel Switch in the up position).
4. Switch on the Overdrive circuit for Filter A, and select the Mode , Cutoff , Q , Q-Drive and IN A to
achieve the sound you want at “maximum” aggression.
5. Play with Filter B’s Mode type and Cutoff frequency and make note of how it “tames” the
distortion coming out of Filter A.
6. Modulate Filter B’s Cutoff frequency to change the tone. Use the XFADE knob to alter the
balance between “tame” and distorted.”
 
Morgasmatron Manual 15