User Manual

[12] PHASE INVERT - Switch this
to the up position to invert the
phase of Filter B signal being
fed to the XFADE.
The most obvious use of
phase inversion is to create
ring modulation (as described
later in the manual), but you
can also use it to create subtly
different timbres when
combining the two filters and
monitoring the MIX output.
[13] XFADE - When monitoring the
MIX output, this knobs sets the
balance between the two
filters. At 12 o’clock, Filters A
and B are equally present at
the MIX output. When the
knob is set clockwise of 12
o’clock, the MIX out contains
more of Filter B’s signal than
Filter A’s. Counterclockwise of
12 o’clock the opposite is true
— the MIX out contains more
of Filter A’s signal than
Filter B’s.
[14] XFADE BALANCE LED -
Visual indication of the current XFADE amount. The brighter the LED on the left, the more
Filter A feeds the MIX output; the brighter the LED on the right, the more Filter B feeds the
MIX output.
[15] XFADE ATTENUVERTER - Reduces and/or inverses how much a signal appearing at the
XFADE CV input jack modulates the XFADE. At 12 o’clock, the XFADE CV input has no effect
on XFADE. Values clockwise of 12 o’clock increase the amount by which the XFADE CV input
skews toward a greater mix of Filter B. Values counterclockwise of 12 o’clock increase the
amount by which the XFADE CV input skews toward a greater mix of Filter A.
[16] SERIES / PARALLEL SWITCH - Switches between a Series connection when flipped up
(causing the output of Filter A to feed the input of Filter B), and a parallel connection when
flipped down (resulting in two totally independent filters processing the signal simultaneously).
Morgasmatron Manual 9