User Guide

Output Type The selection made here determines the type of data
transmitted out the corresponding CVx jack. The selection
impacts the availability of other jack parameters.
Clock (Always) The jack outputs a clock signal. When “Clock (Always)” is
selected, a dedicated Clock Division parameter
materializes, with which you set the rate. The received
MIDI clock will be output regardless of the Transport state
(Start/Stop).
Clock (Running) As with “Clock (Always),” the jack outputs a divided clock
signal, but only when the transport is “running.”
Reset The jack transmits a trigger signal whenever a MIDI
RESET or START message is received.
Run The jack transmits a run gate that goes high (5V) on a
MIDI START/CONTINUE message, and goes low (0V)
when a STOP message is received.
CC Number The jack outputs a control voltage derived from the
selected MIDI CC Number arriving on the MIDI Channel
used by the selected Synth . Voltage polarity is selected
with the CV Polarity option.
CC Number
(High Res) The jack outputs a control voltage derived from the
selected MIDI CC Number arriving on the MIDI Channel
used by the selected Synth . Voltage polarity is selected
with the CV Polarity option. This allows fine-control of
voltages from any external DAW or MIDI Device capable of
transmitting them.
NOTE: Ableton Live users who wish to take advantage of
MIDI 1U’s 14-bit control capabilities can download
Intellijel’s free “High-Res CC” Max for Live plugin from the
Intellijel website, which is included in the Intellijel Config
application download.
Pressure
(Aftertouch) The jack outputs a voltage derived from Channel
Aftertouch messages arriving on the MIDI Channel used
by the selected Synth .
Pitch The jack outputs a 1V/oct pitch signal with a range of ±5V.
The actual pitch is determined by the note value received
on the MIDI Channel used by the selected Synth , plus any
additional pitch bend. Pitch Bend Range, Coarse Tuning,
and Note Priority are all set per-synth in the
Synths
Column .
MIDI 1U System Manual 36