User Guide

MODULE MODES
The MIDI 1U module works in one of two modes: Single or Dual . You can toggle between these two
modes using either the Module Mode parameter in the Intellijel Config app, or by long-pressing
(>2 sec) the LEARN button, as described in Dual Mode Configuration .
Single Mode
This is the default (and most basic) mode of
operation, and is the mode indicated by the panel
graphics. Single mode uses only a single,
monophonic Synth ( synth 1 ), which responds to
MIDI commands on the selected (or learned)
MIDI channel. Incoming MIDI data on that
channel is analyzed and converted to control
voltages, which are sent out the correspondingly
labeled jacks.
Many functions can be learned and configured
from the front panel, while the Intellijel Config app
offers even greater opportunity for customization.
When MIDI 1U is in Single Mode, the LEARN
button is unlit (unless you’re using it to learn parameter values).
Dual Mode
This is an alternate, dual-synthesizer mode that
allows a single MIDI 1U module to control two
separate monophonic Synths ( synth 1 and
synth 2 ). In this mode, you have independent
MIDI control of the pitch, gate and velocity for two
entirely different synths — each of which can
respond to its own MIDI channel. When
Dual Mono is selected, the MOD , CC and TRIG
jacks are repurposed as PITCH , VEL and GATE
jacks for synth 2 ).
You will need to configure any desired CLK
division before entering Dual Mode. When
MDI 1U is in Dual Mode, the LEARN button
glows yellow .
MIDI 1U System Manual 13