User's Manual

IS-SNAKE DevKit Setup Manual
CTR-06-0193-003-B 16  2015 Nintendo
Released: April 6, 2015 CONFIDENTIAL
To use the IS-CTR-CAPTURE software, insert a
USB cable into the CAPTURE TESTER USB port
on the back panel of the IS-SNAKE-BOX.
Insert the DC plug of the AC adapter into the DC
port (DC IN) on the back panel of the IS-SNAKE-
BOX.
Plug the AC adapter into a standard 120 V AC
wall socket.
6.9 Turning the Power On and Off
Follow the procedure below to turn the power on.
1. Turn on the power switch on the back panel of the IS-SNAKE-BOX.
2. The PWR and SYS LEDs on the front of the IS-SNAKE-BOX turn on as follows.
a) The PWR LED briefly turns red.
b) The PWR and SYS LEDs both turn green.
c) The SYS LED turns off.
3. If the power LED on the controller turns on and the LCD screen shows an image, the device can be
used.