User Manual

IS-SNAKE DevKit Setup Manual
 2014 Nintendo 13 CTR-XX-XXXX-XXX-X
CONFIDENTIAL Released: August 7, 2014
5.7 Replacing the Batteries
If the following message appears when using the software or on the HDMI output screen, replace the
batteries as described under "Installing Batteries" above: "The battery might be missing or dead.
Replace the batteries."
5.8 Connecting the Hardware
Follow the procedure below to set up the hardware.
1. Make sure that the power switches of
the IS-SNAKE-BOX units are in the
OFF position.
2. Connect the controller to the IS-
SNAKE-BOX.
3. Connect the L-shape connector to the
controller part, and the straight
connector to the CONTROLLER port
on the front of the IS-SNAKE-BOX.
Firmly push the connector until you
hear it click into place.