User's Manual

IS-NITRO-DEBUGGER Setup Manual
NTR-06-0121-001-A1 6 Copyright  2004 INTELLIGENT SYSTEMS Co., Ltd.
Released: September 10, 2004 Copyright  2004 Nintendo of America Inc.
2 Using This Product Safely
To use the IS-NITRO-DEBUGGER safely, please read the following items carefully to insure the unit
does not malfunction and possibly cause a safety hazard.
 Do not modify or take apart the unit.
 If you notice a problem, immediately stop using the unit.
 Do not allow liquids or foreign objects to enter the unit.
 Do not store the unit in a humid or dusty location.
 Never cover the unit or block ventilation.
 Do not bend, pull, or twist the cables.
 Protect the unit from strong impact.
 .Do not use the unit in locations where the temperature is below 0

C or above 40

C.
 Do not use the unit during an electrical storm. If you hear thunder, stop using the unit immediately
and do not touch it. A lightning strike could cause electric shock.
Regulatory Statement
 This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
 This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
 Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at their own expense.
 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
 This equipment should be installed and operated with minimum distance 20 cm between the
radiator and body. This transmitter must not be co-located or operating in conjunction with any
antenna or transmitter.
 This Class A digital apparatus complies with Canadian ICES-003. The term “IC” before the
equipment certification number only signifies that the Industry Canada technical specifications
were met.
Cet appareil numerique de la classe A est conforme a la norme NMB-003 du Canada.
Le terme “IC” avant le numero d’homologation ne signifie seulement que les normes d’Industrie
Canada ont ete respectees."