Setup Manual
IS-CTR-BOX Set-up Manual
CONFIDENTIAL
Version 0.0.2
4
Special Notes
Notes
Note the following when using IS-CTR-DEBUGGER
Do not turn off the IS-CTR-BOX device during firmware updates. The IS-CTR-BOX device may not function
properly afterward.
During use, do not do anything that would prevent heat dissipation, such as blocking the IS-CTR-BOX airflow
vent, placing the IS-CTR-BOX in a closed container, or placing objects on top of the IS-CTR-BOX.
Connect the CTR for EMULATOR to IS-CTR-BOX. Connect the plug with the green band to the IS-CTR-BOX
and the plug with the black band to the CTR for EMULATOR. Be sure to tighten the connector screws.
When the IS-CTR-BOX device is sent to INTELLIGENT SYSTEMS for repairs or to add options, the system
menu may be updated. Please back up your data and settings before sending in the device. Also, reconfigure
the device after it is returned and before using it.
The liquid crystal display may already have pixels that are illuminated or that do not illuminate. Also, you
might observe irregularity in color or brightness, depending on the angle of view. These are properties of the
liquid crystal display and are not defects.