Setup Manual

IS-CTR-BOX Set-up Manual
CONFIDENTIAL
Version 0.0.2
10
Turning the Power On and Off
Always use the following procedure to turn the power on.
1. Turn on the power switch on the rear panel of the IS-CTR-BOX.
2. The PWR and SYS lights on the front panel of the IS-CTR-BOX illuminate as follows.
I. The PWR light briefly illuminates red.
II. The PWR and SYS lights illuminate green.
III. The SYS light goes out after a few seconds.
3. The device can be used when the CTR for EMULATOR PWR light and the LCD backlight are illuminated.
To turn off the power for the IS-CTR-BOX, use the power switch on the rear panel of the IS-CTR-BOX.
If you are connected CTR for EMULATOR to IS-CTR-BOX, then CTR for EMULATOR don't have to operate a
power management.