User Manual
4
IMPORTANT
NOTE:
FCC Radiation Exposure
Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This transmitter must not be co-located or operating in conjunction with any other antenna
or
transmitter.
FOXCONN declared that J27H023.01 is limited in CH1~11 from 2412 to 2462 MHz (802.11g) by
specified
firmware
controlled in
USA.
This device is intended only for OEM integrators under the following
conditions:
The antenna must be installed such that 20 cm is maintained between the antenna and users,
and
The transmitter module may not be co-located with any other transmitter or
antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the
OEM
integrator is still responsible for testing their end-product for any additional compliance
requirements
required
with this module installed (for example, digital device emissions, PC peripheral requirements,
etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain
laptop
configurations
or co-location with another transmitter), then the FCC authorization is no longer considered
valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will
be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
FCC
authorization.
End Product
Labelling
This transmitter module is authorized only for use in device where the antenna may be installed such
that
20 cm may be maintained between the antenna and users. The final end product must be labelled in
a
visible area with the following: “Contains FCC ID: SRX-FULLW001
”.
Manual Information That Must be
Included
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or
remove this RF module in the user manual of the end product which integrates this
module.
The users manual for OEM integrators must include the following information in a prominent
location
“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for
this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not
be
co-located or operating in conjunction with any other antenna or
transmitter.
1.3 Canada Notice
Industry Canada
Statement
This radio transmitter (IC: 5567A–FULLW001) has been approved by Industry Canada to operate with the
antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device.
Antenna type: 1/2 lambda type
Gain: 2.14 dBi
Impedance: 50 ohms
Le présent émetteur radio (IC: 5567A–FULLW001) a été approuvé par Industrie Canada pour fonctionner avec
les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus
dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour