Installation Instructions

Table Of Contents

PRODUCT NAME:

DH-19

DESCRIPTION:

SPP Bluetooth USB Dongle

OPERATING:

1. Power on by plugging into any USB port.

2. DH-19 advertises as slave.

3. Connect to DH-19 using PC/Laptop/Mobile Phone or any other master device.

4. DH-19 then auto enslaves up to 7 devices.

5. send/receive messages to/from slaves and master.

6. DH-19 can auto detect a disconnection from slave or master

and either auto connect new slave/s or can be enslaved again by master.

VISUAL CUE:

Red LED light will fast flash while waiting to be enslaved.

After master connects, Red LED light will slow flash while searching for slaves.

After all 7 slots for slaves have been filled the Red LED light will stop being

lit up.

If a disconnect happens Red LED light flash while searching or advertising.

PAGE 1
PRODUCT NAME: DH-19 DESCRIPTION: SPP Bluetooth USB Dongle OPERATING: 1. Power on by plugging into any USB port. 2. DH-19 advertises as slave. 3. Connect to DH-19 using PC/Laptop/Mobile Phone or any other master device. 4. DH-19 then auto enslaves up to 7 devices. 5. send/receive messages to/from slaves and master. 6. DH-19 can auto detect a disconnection from slave or master and either auto connect new slave/s or can be enslaved again by master.
PAGE 2
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.