Datasheet

Chapter 3 – Installation
13
Setup
1. Carefully remove the Super DriveLock from its shipping box.
2. Use the supplied Parts List (Table 1-3) to complete an inventory check. See
Appendix B for a picture reference of supplied cables.
3. Review the HARDWARE DESCRIPTION section in this Chapter.
4. The Super DriveLock can be setup for five different types of configurations
depending on needs and available hardware.
• Internal PC Mounting using PCs native S-ATA interface.
The following describes the basic steps for mounting and connecting the Super
DriveLock in a PC using the PC’s native S-ATA interface.
NOTE: Though a PC’s native S-ATA port can be used to connect the SDL unit,
the S-ATA interface is not designed for “hot swapping”. For best results
it is recommended to use the SDL unit connected to the PC’s eSATA
interface. The eSATA interface is designed primarily for “hot swapping”
drives.
a. Power OFF the PC and remove the PCs cover.
b. Insert the Super DriveLock unit in an available 5 1/4” PC drive bay and secure
it using the supplied screws.
Figure 5