Quick Start Guide
ManualsBrandsIntelligent Automation ManualsComputers & AccessoriesARGUS Guardian is a fence-mounted, RF-based perimeter intrusion detection system. This system uses a network of unattended wireless sensors to create a wireless trip wire along a perimeter to provide early warnings against intrusions.
Page | 3
© 2018 Intelligent Automation, Inc.
Figure 1: ARGUS GUARDIAN Gateway connection to PC
Step 3: Start the ARGUS GUARDIAN software
To start the ARGUS GUARDIAN software, click the ‘ARGUS GUARDIAN’ software icon on the desktop. The
splash screen for the ARGUS GUARDIAN View application should appear, then after a few seconds, the
main graphical user interface (GUI) should appear. For a full description of the GUI, modes, buttons, etc.
see Section 0.
Figure 2: GUI software (right)
Step 4: Create a new ARGUS GUARDIAN configuration
Prior to operating the ARGUS GUARDIAN system, it must be configured by defining the node locations
and active fence links to monitor.
- Press the ‘Configure’ button in the upper left corner of the screen.
- Select ‘New’ as the Configuration Type and click ‘Next’.