Quick Start Guide
ManualsBrandsIntelligent Automation ManualsComputers & AccessoriesARGUS Guardian is a fence-mounted, RF-based perimeter intrusion detection system. This system uses a network of unattended wireless sensors to create a wireless trip wire along a perimeter to provide early warnings against intrusions.
Page | 22
© 2018 Intelligent Automation, Inc.
file contains information about the alert type, nodes involved, location, discovery and dismissal time,
and comments.
Figure 25: Alert log file contents
4.9 Plug-in Configuration
Some versions of the RF Fence installation may have optional plug-ins installed, such as camera
monitoring or SMS/MMS notifications. If these are available, additional configuration windows will
appear during the Configuration Wizard and additional options may be available within the system.
4.9.1 Camera Plug-in
The Camera Plug-in allows ARGUS GUARDIAN operators to integrate existing camera systems within the
ARGUS GUARDIAN system. This is configurable with the Configuration Wizard and during Configuration
Mode.
1) Enable cameras for your deployment
a. Press the Configure tool bar button to launch the Configuration Wizard.
b. Navigate to the Camera Monitoring page in the wizard.
c. Set Camera Monitoring to Enabled.
d. (Optional) Scan the network for available cameras. Press the Scan button and all of the
available cameras will be displayed in the list below.
e. (Optional) Test the video stream from the Camera. Press the Show button to open a
stream to the camera. Streams may take up to 5 seconds to initialize.