Quick Start Guide
ManualsBrandsIntelligent Automation ManualsComputers & AccessoriesARGUS Guardian is a fence-mounted, RF-based perimeter intrusion detection system. This system uses a network of unattended wireless sensors to create a wireless trip wire along a perimeter to provide early warnings against intrusions.
Page | 18
© 2018 Intelligent Automation, Inc.
Map View will have the link to the next most recently clicked node made active (if a viable link exists
between the two nodes). This process can continue to enable any number of links.
Unlink Mode 4.6.2.2
Unlink Mode is the opposite of Link Mode – any node clicked in the Map View will in the Map View will
have the link to the next most recently clicked node made inactive. This mode is enabled by clicking the
upper right icon in the Link Configuration Toolbar, and will remain enabled until the icon is clicked again.
Figure 20: A single fence link before (left) and after (right) enabling the link
Line Mode 4.6.2.3
Line Mode enables the user to rapidly activate an entire sequence of links that are in a roughly linear
configuration. This mode is enabled by clicking the lower right button in the Link Configuration Toolbar,
and remains active only until the set of nodes has been selected. After clicking the Line Mode icon, the
user can click and drag to box-select a set of nodes for which to configure as a line. Once the nodes have
been selected, the software will attempt to automatically configure the set of nodes in a roughly linear
topology. See Figure 21 for an example of the Line Mode tool in operation.
Note that this tool can be used to select all nodes in the configuration, or just a subset of the nodes.
Also, the tool will not modify links that are to/from nodes outside of the set of selected nodes. Thus, this
tool can be used to configure a part of the deployment that happens to be linear, and then use the other
methods to configure other links as desired.