Quick Start Guide
ManualsBrandsIntelligent Automation ManualsComputers & AccessoriesARGUS Guardian is a fence-mounted, RF-based perimeter intrusion detection system. This system uses a network of unattended wireless sensors to create a wireless trip wire along a perimeter to provide early warnings against intrusions.
Page | 10
© 2018 Intelligent Automation, Inc.
4 Software Overview
The proper install location for ARGUS GUARDIAN is C:\ARGUS GUARDIAN, where you can find the
application, logs, and configuration files.
4.1 Initial Setup Wizard
When the software is run for the first time on a new machine, it will automatically start the Initial Setup
Wizard upon startup (see Figure 8). Once the Initial Setup Wizard has been completed for a particular
Gateway node, it will not need to run again. The primary purpose of the Initial Setup Wizard is to
establish which serial port is used to communicate with the Gateway node. Carefully follow the on-
screen instructions to enable the software to automatically identify the correct port.
Figure 8: ARGUS GUARDIAN software Initial Setup Wizard
If the Gateway node is changed for some reason, the Initial Setup Wizard will need to be run again so
that the software can be configured to use the correct serial port. To trigger the Initial Setup Wizard to
run again, close the ARGUS GUARDIAN software and run the ‘reset-settings’ script in the installation
directory. Restart the ARGUS GUARDIAN software, and the Initial Setup Wizard should run again.