User's Manual

Page | 3
Proprietary Information,
Intelligent Automation Incorporated
4 Installation & Power up
 Connect the USB cable to a Linux or Windows operating system.
 Connect U.FL cable to port RF1 on the PCB board
 Connect RP-TNC antenna to TNC connector on the radio lab setup.
 Connect Ethernet/Rortary Switch cable to port J4 on the PCB board
 Connect power adapter to a power outlet.
 Switch rotary switch from position 0 to 1. This will power up the radio.
 Wait until green led on the right side of radio board turns green.
5 Connecting to the radio via serial port
With USB cable, we can access the radio via serial port. First, open the terminal app
on the laptop by hitting Windows button and search for terminal. To find out the
connected USB device on Linux OS, you could perform the following command on
the terminal:
$ ls /dev/ttyUSB*
Results:
U.FL Antenna
cable
Ethernet
Connector
Rotary Switch