Quick Start Guide

6
Manual Mode Stand-Alone Set-Up
(no controller or appliance communicating with IntelliFlo)
Manual Mode is used for  rst-time programming, service and testing, or whenever you need to
quickly measure or set  ow rates for equipment and features.
For more information, please refer to the IntelliFlo VF Installation and User’s Guide.
If the IntelliFlo language is not set, select your language:
Press
Menu to access Pool Data.
Press Up/Down arrow to select Language.
Press Select. Press Left/Right arrow to select: Nederlands, Italiano, Francais, Deutsch, Spanish, English.
Press
Enter to save.
Note: Before initial IntelliFlo VF programming, set system valves for your pool
circulation mode.
Pool Data Menu Setting Pool Parameters in Pool Data mode
Pool Data mode is used to give IntelliFlo information about pool volume and water temperature.
You also set the pump language, pump address, pump volume and set the water temperature.
Press
Menu to access Pool Data.
Press Up/Down arrow to select Pool Volume.
Press
Select to set parameters. Press Enter to save.
Pump Address (not used for stand-alone )
Enter pool volume of water. The setting is from 4 - 3785 m
3
.
Stand Alone Set-Up
MENU 12:15
Pool Data
Pool Data
®