Quick Start Guide

15
Features – Modulated Output and Backwash
Backwash Menu The Backwash mode is initiated by pressing the Backwash button.
(The Backwash button doubles for rinse during operation.) A Rinse cycle is automatically executed
after the Backwash cycle. IntelliFlo will display a “Filter Warning” or “Service System Soon” message
when the  lter needs to be cleaned. Before operating, you need to set the Backwash Flow and
Duration, and Rinse Duration.
Note: When using cartridge  lters, the backwash cycle must be performed when cleaning or
replacing  lters. When charging a D.E. system, charge the system  rst during a normal running cycle.
After the  lter is charged, run backwash mode with the  lter valve in the  lter position to reset the %
clean  lter status. Then run the pump in  lter mode.
Always perform Backwash before initial start-up and installation to ensure most
ef cient system performance.
Press Menu and Up arrow or Down arrow to select Backwash menu.
Press Select to display Backwash Flow.
Press Select to access setting.
Press Left arrow and Right arrow to select digit to modify.
Change values by pressing Up arrow and Down arrow.
When value is set, press
Enter to con rm value and save changes.
Setting Backwash Flow