Quick Start Guide

14
M.O. Flo will provide speci c  ow during regular intervals for a period of time de ned by the user.
The Modulated Output feature automatically increases pump  ow to allow the system heater to check
the water temp and switch on if necessary. This feature also allows  ow control  exibility if  lter cycle
 ow is less than needed for certain devices. M.O. Flo also allows you to program  ow intervals that can
be used for water effects. You will need to enable M.O. Flo, and set the  ow rate, run times, and intervals
between run times. M.O. Flo will operate only during the “Filter Mode” time cycles.
Press Up arrow or Down arrow to select M.O. Flo.
Press Select to access M.O. Flo menu settings.
Press
Select and Down arrow to enable. Press Enter to save.
Press Down arrow to access Set Flow setting.
Press Select to access setting.
Press
Left arrow and Right arrow to select digit to modify.
Change values by pressing Up arrow and Down arrow.
When value is set, press Enter to con rm value and save changes.
Press Down arrow to access Set Run Time or Set Interval Time.
Press Select to access setting.
Press Left arrow and Right arrow to select digit to modify.
Change values by pressing
Up arrow and Down arrow.
When value is set, press Enter to con rm value and save changes.
Modulated Output
(M.O. Flo)
Enabling M.O. Flo
Setting M.O. Flo
Flow Rate
Setting M.O. Flo
Run Time and
Interval Settings