Quick Start Guide

Setting: Start/Stop Cycle – Clock/Screen Contrast

Cycle Start and Stop Each Cycle has two screens, one for Start Cycle and one for Stop Cycle.

Press

Down arrow to access Start Cycle and set starting time.

Press Down arrow again to access Stop Cycle and set stop time.

Repeat this procedure for every Cycle.

Press

Down arrow to scroll to Time/Contr.

The Start Cycle 2 will be enabled only if 2 cycles per day have been entered under previous screen.

You can program up to four start and stop cycles per day.

The more time the Intelli o VF is given to operate, the less power and  ow will be needed for

turning over the pool.

Setting Clock

Press Select to access Set Time.

Make sure to set AM/PM or 24H correctly.

IntelliFlo can store the correct time for up to 96 hours after power is shut off.

After 96 hours, IntelliFlo VF’s clock must be reset.

Adjusting Screen Contrast

Press Down arrow to scroll to Contrast.

Screen contrast levels can be set from 0-9.

Avoid setting at 0 unless you are unable to read the screen due to bright sunlight.

Filter 12:15

9:00

Start Cycle 1

Enabled

Filter 12:15

21:00

Stop Cycle 1

Enabled

MENU 12:15

Time/Contr

Time/Contr 12:15

Contrast Level

Time and Contrast Menu