Owner's Manual

3
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Owner’s Manual • 9/20
Federal Communications
Commission (FCC) Compliance
This gas appliance electronic control module (ECM)
has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment o and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit di erent from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
Changes or modi cations not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
The FCC certi cation number and compliance statement
are displayed on the Electronic Control Module (ECM)
housing as follows:
FCC ID: ULE2564-130
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and,
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Industry of Canada (IC) Compliance
The IC certi cation number is displayed on the
Electronic Control Module (ECM) housing as
follows:
This gas appliance electronic control module (ECM)
complies with Industry Canada license exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any inter- ference,
including interference that may cause unde- sired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux
onditions suivantes: (1) l’appareil ne doit pas produire
de brouil- lage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, meme
si le brouillage est susceptible d’en compromettre le
fonctionnement.
IC: 6732A-2564130