User's Guide
Table Of Contents
- Chapter 1. Precautions
- Chapter 2. Certifications
- Chapter 3. Introduction
- Chapter 4. Planning Installation
- Chapter 5. Installing ADU
- Chapter 6. Installing BDU
- Chapter 7. Operating BDU
- Chapter 8. Using AptusLX
- Chapter 9. Specification
- Chapter 10. Warranty
- Chapter 11. Appendix
- Chapter 1. Precautions
- Chapter 4. Planning Installation
- Chapter 5. Installing ADU
- Figure 9: Antenna Dimensions
- Figure 10: ADU Mounting Template
- Figure 11: Recommended Mast Design using Inner Holes (with M6 Bolts)
- Figure 12: Recommended Mast Design using Outer Holes (with M10 Bolts)
- Figure 13: Mounting Antenna using Inner Holes (with M6 Bolts)
- Figure 14: Mounting Antenna using Outer Holes (with M10 Bolts)
- Figure 15: Installing 40A Pole Bushing inside Pole Tube
- Figure 16: Installing Pole Bracket
- Figure 17: Mounting Antenna on Pole Mounted Bracket
- Figure 18: Vent Hole
- Figure 19: Connecting RF Cable using Inner Holes (with M6 Bolts)
- Figure 20: Connecting RF Cable using Outer Holes (with M10 Bolts)
- Chapter 6. Installing BDU
- Figure 21: BDU Dimensions (Direct Mounting Type)
- Figure 22: BDU Dimensions (19-inch Rack Mounting Type_Optional)
- Figure 23: BDU Mounting Template
- Figure 24: Direct Mounting of BDU
- Figure 25: Attach Connector Tray to BDU
- Figure 26: Attach Rackmount Plate to BDU
- Figure 27: Intellian C700 System with Connected Devices
- Figure 28: BDU Back Panel View
- Figure 29: LAN Ports (RJ45) Pinout
- Figure 30: Phone Port (RJ14 & 6P4C) Pinout
- Figure 31: Using Cable Splitter with RJ14 Phones
- Figure 32: GPIO Connector Pinout
- Figure 33: Power Connector Pinout
- Figure 34: BDU to Antenna Cable Connection
- Figure 35: Grounding Stud Connection
- Chapter 7. Operating BDU
38
Intellian C700 - Marine Satellite Communication System
Chapter 7. Operating BDU
The BDU and ADU are connected through single coaxial cable through which power from BDU is delivered to
ADU and Ethernet data is exchanged between the BDU and ADU. The BDU controller is responsible for all the
terminal management, system monitoring, control, error detection, and maintenance operations.
7.1 BDU Front Panel
The following gure shows the BDU's front panel.
LED Indicator Power Button
The following table shows status indicators on the face of BDU.
LED Indicator Color Description
Power
Off The BDU is powered off.
Blinking
The BDU is booting a system.
The BDU is calibrating a system.
The system is in error.
There is no SIM card inside BDU.
Steady Green The BDU is powered on.
Satellite
Off The antenna is not connected to a satellite.
Blinking
The antenna is acquiring a satellite.
The antenna is searching for a satellite.
Steady Green The antenna is connected to a satellite.
Event
Off The antenna has no event (call or data).
Blinking
The antenna has an alert, an unread message, an incoming
call.
Steady Green The antenna has a voice or data.
NOTE: When 3 LEDs blink simultaneously, the BDU is in a low power state. Check the current input voltage
status.
Figure 36: BDU Front Panel