User's Manual
Table Of Contents
- 1 Introduction
- 2 Product Description
- 3 Appendix I. Ancillary Devices – Antenna, Cable and other Passive Device
- 4 Human RF Exposure – Maximum Permissible Exposure Evaluation
Intelibs, Inc Proprietary and Confidential Page 30
30
• Alarms: Current alarms of all registered DAS systems.
• SNMP settings: SNMP environment settings such as trap IP, community, V3 user, etc.
• Site settings: Assign site and location information to each registered Das systems.
• User settings: Add/delete web user and change user’s password
• Support: Intelibs’ support information.
• About us: Redirect to Intelibs’ web page.
• Log Off: Logging off current user’s session.
Before using web interface, followings should be assigned and set correctly:
• Master Unit’s IP address
• RHU system’s IP address
• Master Unit’s IP address on RHU system
Figure 2-16 shows web interface flow over IP network.
Figure 2-16 Web interface flow
`
If IP network connection is established successfully, then parameters of SRU can be set by Web browser,
and all status information can be reported to Web browser.
Following is one example of Web operation which sets the upper limit of SRU chassis’ temperature.
Step 1
• Open Web browser such as Internet Explorer or Chrome.