User's Manual
Table Of Contents
- 1 Introduction
- 2 Product Description
- 3 Appendix I. Ancillary Devices – Antenna, Cable and other Passive Device
- 4 Human RF Exposure – Maximum Permissible Exposure Evaluation
Intelibs, Inc Proprietary and Confidential Page 25
25
• If SRU’s ID is chosen, then press “Install” button. After Install, press “Refresh”.
• If SRU is installed properly, a small box on the left side of SRU’s ID turns to GREEN, otherwise it
turns to RED.
Step 9
• At “Repeater Browser” window, click the DAS system to be managed, then the selected DAS
system’s control window will pop up.
If connection is established successfully, then all parameters of SRU can be set by LMT terminal, and all
status information can be reported to LMT. SRU’s status and parameters controllable by LMT are
described in Table 2-11, 2-12, and 2-13.
Table 2-11 General/Environment/Optic
Status group
Parameters
LED
Settable
Description
Version Firmware Version of the DAS system
DAS Type
The type of the DAS system
Name
√
Set following information of the DAS
- Name
- Model Number