Tus neeg siv phau ntawv

7
» Economy Mode: the sensor takes a reading of the environment and immediately after motion detection and triggering
it goes into sleep, which can last for a period of 30 seconds (environment with little movement) up to 2 minutes (environ-
ment with a lot of movement). During this period the indication LED is not activated and no new triggers are generated,
as a notication has just been sent to the switch. After the sleep time, the sensor is monitoring the environment until
detecting a new movement.
Trial period
15 min
Period of
stabilization
Time the sensor remains on
Economy Mode
30 seg - 2 min
After inserting
the battery,
the LED is
blinking and
there is no
detection.
At any detection
the LED lights
up and
generates a
trigger.
After detecting the first
movement, the sensor turns on
the LED, triggers and enters the
sleep period.
During this period the
LED does not light and
no new triggers are
generated.
After the
hibernation time, the
sensor returns to
detect and generate
triggers in the
central, starting the
cycle again.
Advantage of the Economy mode: this ability to learn from the environment, means that in places with high degrees
of movement, periodic and non-continuous shots are generated, in turn, saving battery power.
5.3. IVP 4000 smart sensor supervision adjustment
The SUPERV jumper (JP3) is used to select between supervised (FSK) or unsupervised (OOK) modes. With jumper JP3 open
the sensor is in supervised mode (FSK). With jumper JP3 closed the selected mode is unsupervised (OOK). The type of
supervision to be used will depend on the receiver’s compatibility with the control panel.
Factory standard: unsupervised