Tus neeg siv phau ntawv
10
Com o jumper JP2 na posição 1 (CONT) o sensor funcionará no modo CONT (Continuo inteligente), operando da seguinte forma:
After power-up, the sensor will work continuously for 30 minutes so that the installer can make all the adjustments to the sensor.
After this time the sensor goes into intelligent continuous mode.
Intelligent continuous mode operation: the sensor can transmit up to 3 consecutive shots, after the last shot, the
sensor goes into SLEEP mode (low consumption mode without transmission to the central alarm) for 2 (two) minutes. The
sensor will only detect and transmit a trigger again if there is 2 (two) minutes without movement in the environment. After
the 2 (two) minutes the sensor will be able to transmit up to 3 consecutive shots within an interval of 135 seconds if there
are movements. Right after the 3 shots or 135-second interval, the sensor will enter the Hibernation period, that is, it needs
to stay again for two minutes without movement to be able to detect and transmit a shot. During this hibernation period the
sensor will not transmit to the control panel, but the LED will light indicating that the sensor is detecting normally.
For a better understanding of the smart continuous mode, check the timeline below:
30 min
After placing
the battery the sensor
stays in stabilization
and the LED stays
blinking. Note: do not
register the
sensor on switch in this
period, wait 50 sec so
that the sensor enter
mode continuous.
In this mode any
detection o LED
lights up and
generates firing.
No
detects
mode
Stabili-
zation
50 sec
Continuous
mode
Time the sensor remains on.
Smart continuous mode
2 min
In this mode the
sensor can shoot and
to transmit up to 3
times in a break
maximum of 135
seconds before to
enter the way of
hibernation.
In this period of
2 min, if there is
movement in the
place, the sensor
waits for the last
movement to
start counting
the two minutes.
In the period of
hibernation only
the LED lights up
indicating that the
sensor is detecting
normally.
in this mode the
sensor needs go 2
minutes without
detect motion to
return to shoot and
transmit to alarm
central.
7.3. IVP 4000 smart sensor supervision adjustment
» For board version 4410030/2 or 4410030/3: to change the modulation from OOK to FSK, simply remove the battery
from the sensor, open the OOK/FSK jumper (JP3) and then put the battery back in its original position. Once this is done,
the sensor will operate in FSK mode. Changing the FKS mode to OOK (factory default) is also simple, just remove the
battery from the sensor, close the OOK/FSK jumper terminals (JP3) again and replace the battery in the original position.
Once this is done, the sensor will return to operating in
OOK
mode.
» For board version 4410030/1: to change the modulation from OOK to FSK, just remove the battery from the sensor,
cut the path (FSK) indicated on the board by a small arrow (gure A) and then replace the battery in its original position.
Once this is done, the sensor will operate in FSK mode. Changing the FSK mode to OOK (factory default) is also simple,
just remove the battery from the sensor, rejoin the two pads of the FSK track indicated on the board by the arrow, replace
the battery in the original position. Once this is done, the sensor will return to operating in
OOK
mode.
Break here