User Guide

56
4.3 INSTALLING THE ACCESSORIES
4.3.1 Console OP 1610
The OP 1610 is supplied with connection and jack and installation socket.
Observation
:
- Do not strip of the wires;
- use 0,4 mm2 wires
- the maximum distance is 50 m.
Important
:
- before insatalling your Ti, make sure that the PABX is disconnected.
To install
:
- connect the installation socket to CN27 as per the figure;
- put jumper J4 in position console;
- connect the cord to the console jack and the wall socket and then turn the PABX
on.
Attention
:
- the wiring of the console (TX, RX, VOP and GNDA) must not be installed with
the extension wiring (RA and RB), to avoid interferences.