User Guide

55
The PABX can be connected to a serial printer as shown below :
- default RS 232;
- 8 bits per character;
- no parity;
- 2 stop bits;
- 4800 BAUDS.
Installing parallel printer : install the call logging kit to CN34 of the main board as
per the figure :
4.2.11 Programming the PABX via PC
You can program your PABX via PC using intelbras PABX software programmer,
the software is supplied with your PABX manual or canbe downloaded from our site
www.intelbras.com.
To install :
- The software communication is through serial port;
- Install the software on your PC;
- connect the serial port of your PC to the serial port of the PABX (CN29) as per
the following figure :
CN29 of PABX DB25 of PC DB9 of PC
TXDA Pin 03 (Rx) Pin 02 (Rx)
RXDA Pin 02 (Tx) Pin 03 (Tx)
GNd Pin 07 (GNd) Pin 05 (GNd)