User Guide

29
3 ACCESSORIES
3.1 DOORPHONES
You can connect 2 doorphones to your PABX. Once the doorphone is installed you
must program its physical position following the steps in item 3.1.1 or 3.1.2 as per the
installed model. To cancel a doorphone follow the steps in item 3.1.3.
Important
:
−
If after installing a doorphone, you want to install an interface for another
doorphone in the same position; you should disactivate the existing doorphone
and reprogram the new physical position of the new doorphone.
3.1.1 Physical position for doorphone PI 100
Once in programming mode, do the following :
Doorphone 1
☞
 
+
PHYSICAL POSITION
(01 to 63)
+
 
, w
ait for tone or confirmation prompt.
Doorphone 2
☞
 
+
PHYSICAL POSITION
(01 to 63)
+
 
, w
ait for tone or confirmation prompt.
Important
:
−
See item 4.3.4. on how to install the PI 100
3.1.2 Physical Position of thrid party doorphones using IP 700
You can access our website for a list of compatible doorphones.
Once in programming mode,do the following :
Doorphone 1
☞
     
w
ait for tone or confirmation prompt.
•
Doorphone 1 must use position 04
.
Doorphone 2
☞
     
w
ait for tone or confirmation prompt.
•
Doorphone 2 must use position 05
.
Important
:
−
see item 4.3.3. on how to install the IP 700
3.1.3 Disactivate physical position
Once in programming mode,do the following :
☞
 
+
PHYSICAL POSITION
(01 to 63), position of doorphone
+
EXTENSION Nº
,
w
ait for tone or confirmation prompt.