User Guide

Capítulo II
26
2.15 EXTENSION PRIVATE CODE
You can set a private code, between 00 and 99, for you extensions to make
external calls.
Once in programming mode, do the following :
☞
 
+
CODE
- 00 to 99
+
EXTENSION Nº
,
w
ait for tone or confirmation prompt.
Cancel
☞
 
+
CODE
- 00 to 99,
w
ait for tone or confirmation prompt.
Factory setting
: no code programmed.
2.15.1 Call Transfer using a Private Code
Once in programming mode, do the following :
☞
   
,
w
ait for tone or confirmation prompt.
Disactivate
☞
   
,
w
ait for tone or confirmation prompt.
Important
:
−
Calls made and transferred using private code will be shown as originating from
that extension.
Factory setting
: call transfer using private code disactivated.
2.16 SIGNALING UNANSWERED CALLS THROUGH LEDS
You can set the PABX to signal unaswered calls through the LEDs of the key
systems.
Once in programming mode, do the following :
LEDs OFF
☞
   
,
w
ait for tone or confirmation prompt.
LEDs flashing
☞
   
,
w
ait for tone or confirmation prompt.
Important
:
−
The LEDs of the operator console will always flash regardless of the feature being
activated or not.
Factory setting
: leds disactivated.