User Guide

Capítulo II
24
2.11 AUTO-NIGHTMODE
You can set your PABX to enter and exit nightmode at regular hours automatically.
You must set the hours and select auto-nightmode for everyday or weekdays.
Once in programming mode, do the following :
Time to exit
☞
 
+
HOUR and MINUTE
,
w
ait for tone or confirmation prompt.
Time to enter
☞
 
+
HOUR and MINUTE
,
w
ait for tone or confirmation prompt.
Disactivate auto-nightmode and all schedule
☞
 
,
w
ait for tone or confirmation prompt.
Programming the type of attendance
Auto-nightmode - everyday
☞
  
,
w
ait for tone or confirmation prompt.
Auto-nightmode - wekdays
☞
  
,
w
ait for tone or confirmation prompt.
Disactivate auto-nightmode
☞
  
,
w
ait for tone or confirmation prompt.
Important
:
−
1st hour of the day puts the PABX off the state of auto-nightmode;
−
you can set up to 24 different times to be programmed as per the order of
activation;
−
hour and minute should bear two digits, the hour should be between 00 and 23.
Example
: you want the PABX to enter auto-nightmode during weekdays at 19:00
and return to daymode at 08:00.
Press
86
+
0800
and
86
+
1900
. Press
832
to activate the service.
Factory setting
: auto-nightmode disactivated.
2.12 INCOMING CALLS CLASSIFICATION
Incoming calls classification can be displayed using a caller ID board and a key
system or a billing software. You should first have the service activated by your
carrier.
Categ. 0
( unknown source – failure);
1 – Reg. Subs.
(regular subscriber);