User Guide

2. Enter programming mode

Note: to modify the technical parameters of your alarm center, it is recommended to contact a qualied technician.

2.1. Enter programming mode

To modify any of the center’s operating parameters, always enter the programming mode. To do this, enter the following

sequence:

Enter + Password (Master or Installer Password)

2.2. Exit programming mode

To exit programming mode, enter the master password or the installer password (the same password used to access

programming mode).

3. Quick programming reference

This quick reference assumes that the center is in programming mode and presumes that the entire manual has been read

and the result of each function is known.

Manual available on the website

www.intelbras.com.br.

When accessing the programming mode, editing or viewing some programming through the keyboard, if the sequence or

password is accepted, 2 conrmation beeps will be emitted, otherwise, a long error beep will be emitted, in which case

you must start entering the password or command again.

3.1. Wireless devices

Attention: If it is not possible to register the device to the alarm center, reset it by pressing the synchronization button

for approximately 10 seconds until the device LED indicator ashes red twice. This process ensures that the device will not

be linked to any other system, the keypad will display the message

Keypad not registered

and then the message

keypad,

indicating that it can be registered again.

Registration by synchronization key

Press and release the synchronization key of the alarm center and wait until LED 3 lights up continuously, indicating that the

center is ready for registration of wireless devices. When you have nished registering all devices, press the synchronization

key of the alarm center again and check that LED 3 is out of Continuous mode (blinking indicating normal operation), showing

that the center has exited wireless device registration mode.

Maximum device capacity:

» Wireless keyboardss 16

» Remote controls 98

» Wireless sensors 64

» Wireless sirens 16

» Repeaters 04

» PGM actuators 16

Note: when physically deleting the devices, they must be deleted from the center’s memory through programming.

Otherwise, the wireless device supervision fault will be generated for these devices.

Keyboard commands for wireless devices

Keyboard

» Change the system language

Enter + 854 + I + Enter

» I = 0: Portuguese

» I = 1: Spanish

» I = 2: English

Note: function available as of version 1.0.1 of the XAT 8000 keyboard.