User Guide

22
» Program password
Enter + 823 + O + Enter , where O = 1 or 2 (operator 1 or operator 2).
After the command, type the password (according to the operator used) and then press the
Enter key to conrm.
» Programar APN
Enter + 824 + O + Enter , where O = 1 or 2 (operator 1 or operator 2).
After the command, type the APN (according to the operator used) and then press the
Enter key to conrm.
» Program the PIN (Personal Identication Number)
If you want to use the PIN, perform the command in sequence, otherwise go to the following command.
If the PIN is wrong, the chip will be blocked.
Enter + 825 + O + 4-digit PIN number + Enter , where O = 1 or 2 (operator 1 or operator 2).
» GPRS heartbeat interval (link test)
Enter + 827 + TTM + Enter , where TTM = Heartbeat time interval from 000 to 255 minutes (default: 005 minutes).
» DNS servers for GPRS
Enter + 828 + S + Enter , where S = 1 or 2 (Server 1 or Server 2).
After entering the command, type the DNS server code (according to the server used) and then press the
Enter key to
conrm.
» Interval between GPRS connection attempts
Enter + 829 + TG + Enter , where TG = interval time of reconnection attempts from 00 to 20 (default: 00 minutes) .
» Cloud Connection
Enter + 512 + Enter
After the command, use the keys on the keyboard to enable option 6 and press the Enter key to conrm.
» Exit programming mode with the installer’s password
Installer’s password (default: 9090 ).
» Check GPRS signal level
Press the Menu key, navigate using the arrow keys, access the GPRS Signal option and check the signal by dialing 1 to 10.
» Check connection to IP receiver service
Press the Menu key, navigate with the arrow keys, access the Connections option, and check that the checkbox for the
GPRS: IP1 and/or IP2 option is lled in. If so, the center connects via GPRS to the IP receiver software through the chips
that were enabled.
Programming GSM Calls
» Program GPRS channel options to enable chips
Enter + 832 + Enter.
After the command, use the keyboard keys to enable options 1 (chip 1), 2 (chip 2) and press the Enter key to conrm.
» Program phone
Enter + 84 + M + Phone number up to 20 digits + Enter, where M = memory number ranging from 1 to 5.
The phone number must have a maximum of 20 digits and be in the format: 0 + operator code + area code + phone
number starting with the digit 9.
Contact-ID codes
» Enable/Disable events
As can be seen in the following commands, the event can be blocked if it is set to 000 ( it will not be sent to the IP receiver)
and enabled when registering FFF (it will be sent to the IP receiver).
After entering the command, enter the value 000 to deactivate or FFF to activate and press the Enter key to conrm.
» Enable/Disable Contact-ID code for zone opening type events
»
Enter + 901 + ZZ + Enter
ZZ = zone from 01 to 64